Starting engine

Station

Wet clay250 g

Preparing your clayOpening the local material engine

10 mm

Wet

250 g

Ram’s-head wedging

Cycles: 0
Preparation estimate: 40%

Height: 50 mm
Width: 56 mm
Material volume: 125 cm³
Body mass: 250 g

Finger contact

A small, precise contact for opening and pulling.

Force limit12 NWall gap10 mmSupport offset0 mmMove contacts together

Inspection

2 mm resolution. Features below three grid cells are approximate.

Export

Export the current material surface.

Wheel at restSpace to start

rpm

Lutio

New clay

Wet clay mass250 gSimulation resolution

One illustrative clay body. Your current work is saved locally before starting.

Lutio

Controls

Tool contact

Drag in the workspace to place the contacts. Small, steady gestures are easiest to control. Use a light force to begin. Pen pressure scales the force limit.

Wheel

Press Space to start, or drag the exposed wheel rim to turn it by hand in either direction. Rotation carries the clay through the contacts. Stop the wheel to leave a local impression. For opening, move a contact down through the top; use opposing contacts to pull a wall.

History

Every completed stroke becomes a history point. Select an earlier point, then make another gesture to branch. Download .clay files to keep complete backups.

Start / pause: Space
Orbit / zoom: Right drag / scroll
Choose a tool: 1–4
Switch contact: X
Adjust the gap: Shift + scroll
Momentary section: Hold I
Keyboard contact: Focus workspace, use arrows
Undo / redo: ⌘ / Ctrl + Z / Shift Z

Experimental, illustrative material. Thin walls and numerical limits are visible; behavior has not been calibrated against a real clay body. Projects stay in this browser. Export a .clay backup before clearing browser data.

Library

No saved documents.